How to install the rear view camera
Rear-view cameras are mainly divided into three categories: external vehicle-mounted cameras, embedded vehicle-mounted cameras, and dedicated vehicle cameras, which are subdivided into front-view cameras, rear-view cameras, left-view cameras, right-view cameras, rear-view vehicle cameras, and side-view cameras. Camera, wired camera, wireless camera.
There are five main ways to install the rear view camera: the first is to install it in the middle of the license plate light, which is mainly a general-purpose external car camera, which can be fixed with two screws, which is easy to install and does not damage the original car; This kind of camera is suitable for installation in the car with no handle between the two license plate lights; the second is to install in the position of the license plate lamp, which is to remove the license plate lamp of the original car, and then the camera is just stuck in the position of the license plate lamp, which is easy to install. A small number of parts need to be fixed by screws; the third type is to install in the gap left in the middle or beside the license plate lamp, the car camera directly snaps into the gap, and the installation is also very convenient; some replace the handle; the fourth type is to install on the license plate frame Use the two anti-theft screws on the license plate frame to fix it; the fifth is to install a hole in the bumper below the license plate frame, and then press the car camera in and adjust the direction. It looks very Beautiful.
To install the rear view camera, first insert one end of the video cable delivered by the car camera into the video input port of the car monitor and portable GPS navigator, and insert the other end into the video output port of the car camera. Finally, insert the DC power cord plug into the power input port of the camera. Then connect the DC power cord to the power cord of the reversing light, and be sure to install the car camera according to the instructions, otherwise the car camera chip will be damaged.
There are five main ways to install the rear view camera: the first is to install it in the middle of the license plate light, which is mainly a general-purpose external car camera, which can be fixed with two screws, which is easy to install and does not damage the original car; This kind of camera is suitable for installation in the car with no handle between the two license plate lights; the second is to install in the position of the license plate lamp, which is to remove the license plate lamp of the original car, and then the camera is just stuck in the position of the license plate lamp, which is easy to install. A small number of parts need to be fixed by screws; the third type is to install in the gap left in the middle or beside the license plate lamp, the car camera directly snaps into the gap, and the installation is also very convenient; some replace the handle; the fourth type is to install on the license plate frame Use the two anti-theft screws on the license plate frame to fix it; the fifth is to install a hole in the bumper below the license plate frame, and then press the car camera in and adjust the direction. It looks very Beautiful.
To install the rear view camera, first insert one end of the video cable delivered by the car camera into the video input port of the car monitor and portable GPS navigator, and insert the other end into the video output port of the car camera. Finally, insert the DC power cord plug into the power input port of the camera. Then connect the DC power cord to the power cord of the reversing light, and be sure to install the car camera according to the instructions, otherwise the car camera chip will be damaged.
